| 1. | Small - sized waste solution treatment device
小型废液处理装置
|
| 2. | Test method for rubber thread - deterioration due to washing solution treatment
橡胶绳因洗涤液浸渍变质的试验方法
|
| 3. | Effect of the cooling rate during solid solution treatment on the properties of 1420 alloy
非晶合金结构与耐蚀性能的影响
|
| 4. | Study effects of solution treatment on microstructures and properties of 2014 aluminium alloy
固溶处理对2014铝合金组织和性能的影响
|
| 5. | Effect of solution treatment in an electric field on micr ostructure and properties of 1420 al - li alloy
固溶处理冷却速度对1420合金性能的影响
|
| 6. | Effect of solution treatment on microstructure and properties of high - purity and high - strength aluminum alloy
固溶处理对高纯高强铝合金组织和性能的影响
|
| 7. | Ht sub - factory : complete process of annealing , quenching , tempering , quenching and tempering , solution treatment etc
热处理厂：可完成退火,正火,回火，调质,固溶处理等工艺
|
| 8. | The sbf cultivation results by different surface modification methods were : nano - tio2 coating > alkali solution treatment > tio2 coatings sintered in normal pressure > tio2 coatings sintered in vacuum
不同表面改性方法的sbf培养结果比较为：纳米二氧化钛涂层碱液处理方法常压下烧结二氧化钛涂层真空下烧结制备的涂层。
|
| 9. | Based on these experiments , it may be claimed that there is segregation of sn to grain boundaries in 0 . 15 % c steel during cooling from a high solution treatment temperature . this segregation reduces grain boundary cohesion , which results in low hot ductility and intergranular fracture
通过试验和计算得出: sn在0 . 1swt . % c钢中发生非平衡晶界偏聚的临界时间为1245左右，临界冷却速率大约为8 / s ，与试验结果基本一致。
|
| 10. | Zircaloy - 4 sheet , which was cold - worked followed by recrystallization annealing , exhibits longer lcf life in the rolling direction than that in the transverse direction , and the fact that difference in lcf life between both directions becomes larger as the range of plastic strain becomes lower can be attributed to the texture effect , p - solution treatment deteriorates the alloy ' s lcf property because the treatment lowers the average value of alloy ' s schmid factors , and the subsequent annealing - treatment in a - phase range has a impact on the lcf properties , i . e . the subsequent annealing - treatment at 500 ? for 1 . 5h results in better property than that at 750 for 1 . 5h , which comes mainly from the fact that the alloy annealled at 500 for 1 . 5h has lower amount of the precipitate particles than the alloy annealled at 750 for 1 . 5h
对于冷加工后经再结晶退火处理的zr - 4合金，轧制方向的低周疲劳寿命比横向要大。随着_ p的降低，两个方向的低周疲劳寿命的差别相应增加，这是由于合金中存在织构的缘故。冷加工后经再结晶退火处理的zr - 4合金在固溶处理后，抗疲劳性能明显降低，这主要是由于固溶处理降低了合金的schmid因子；固溶处理后在相区的退火对疲劳性能有影响，即500 1 . 5h退火的抗疲劳性能要优于750 1 . 5h退火，这主要与500 1 . 5h退火的合金中沉淀相粒子的数量较少有关。
|
您当前位置：